Sample old tip


Ripping a workpiece to size on a table saw is much easier when you have a good way to hold the workpiece down. This feed roller set provides downward pressure as well as inward pressure towards the fence as you rip the workpiece.
SLIDE 1 of 9

Sample old tip

Slide title #1

Ripping a workpiece to size on a table saw is much easier when you have a good way to hold the workpiece down. This feed roller set provides downward pressure as well as inward pressure towards the fence as you rip the workpiece.

The rollers simply mount on top of the table saw rip fence. You easily mount them by creating an L- shaped or U-shaped axillary fence made from ¾” plywood.
SLIDE 2 of 9

Sample old tip

Slide title #2

The rollers simply mount on top of the table saw rip fence. You easily mount them by creating an L- shaped or U-shaped axillary fence made from ¾” plywood.

A set of universal fence clamps holds the L-shaped auxiliary fence in place. The clamps shown here are fully adjustable for most fence widths.
SLIDE 3 of 9

Sample old tip

Slide title #3

A set of universal fence clamps holds the L-shaped auxiliary fence in place. The clamps shown here are fully adjustable for most fence widths.

The universal fence clamps require a 3/8” hole drilled at both ends for the clamp to fit into. Drilling the holes on the drill press with a handscrew clamp keeps the holes perfectly aligned.
SLIDE 4 of 9

Sample old tip

Slide title #4

The universal fence clamps require a 3/8” hole drilled at both ends for the clamp to fit into. Drilling the holes on the drill press with a handscrew clamp keeps the holes perfectly aligned.

Once the holes are drilled you can mount the auxiliary fence and roller assembly onto the table saw fence with the universal fence clamps.
SLIDE 5 of 9

Sample old tip

Slide title #5

Once the holes are drilled you can mount the auxiliary fence and roller assembly onto the table saw fence with the universal fence clamps.

To use the rollers simply adjust the height of each roller about 1/8” to 1/4” below the face of the workpiece. You can also adjust the rollers from side to side as well.
SLIDE 6 of 9

Sample old tip

Slide title #6

To use the rollers simply adjust the height of each roller about 1/8” to 1/4” below the face of the workpiece. You can also adjust the rollers from side to side as well.

As you feed the workpiece each roller applies a small amount of downward pressure. It also pulls the workpiece slightly towards the fence, keeping it aligned with the cut.
SLIDE 7 of 9

Sample old tip

Slide title #7

As you feed the workpiece each roller applies a small amount of downward pressure. It also pulls the workpiece slightly towards the fence, keeping it aligned with the cut.

The rollers roll easily so feeding the workpiece through the table saw blade is smooth, easy and most importantly, safe!
SLIDE 8 of 9

Sample old tip

Slide title #8

The rollers roll easily so feeding the workpiece through the table saw blade is smooth, easy and most importantly, safe!

SLIDE 9 of 9

Sample old tip

Slide title #9

Test for video?