If you’re building cope-and-stick doors and drawer fronts, our new Rail Coping Sled will be an indispensable helpmate. With its smooth-sliding phenolic base, and sturdy toggle clamp holding your stock firmly against the fence, your rails will travel unwaveringly past the cutter for the cleanest, squarest cuts you can imagine. Particularly with drawer fronts, which sometimes use very narrow rails, the sled prevents parts from dipping in too deep and keeps your hands safely out of harm’s way. A sacrificial block can be attached to the fence to prevent end grain blowout, while an abrasive strip prevents the workpiece from wandering. Unlike many jigs that use the miter slot, our sled uses only the fence as a reference, so there is no need to waste time aligning the miter slot parallel with the fence. In addition, the coping sled has been redesigned so that the reference edge is a separate clear guide rail elevated 2” above the table, meaning there is no risk of cutting into the sled.